![3dlabprint p38 normal or high quality 3dlabprint p38 normal or high quality](https://i.etsystatic.com/17438906/r/il/47e7b2/1801414955/il_fullxfull.1801414955_sidu.jpg)
In addition, give special consideration to any future uses as you may expand you business in the near future.
#3dlabprint p38 normal or high quality install
If you need to install an 40 ton overhead crane in an existing building structure, we can design the crane to fit your facility conditions. Installing An Overhead Crane In An Existing Building Structure Technical Parameter of AQ-NLH European Type Electric Hoist Overhead Crane
![3dlabprint p38 normal or high quality 3dlabprint p38 normal or high quality](https://ftforumx2.s3.amazonaws.com/2017/03/147674_4cf7b4303a3a24c437648d0808e581bb.jpg)
Spools are made from recycled plastic waste.Technical Parameter of AQ-QD Double Girder Overhead Crane The filament is produced from premium ingredients, with tight tolerances on our automated production line and comes in a resealable bag for convenient use.
![3dlabprint p38 normal or high quality 3dlabprint p38 normal or high quality](https://i.ytimg.com/vi/AhhF5vumgS4/sddefault.jpg)
Parts can be easily sanded to make a nice surface finish. Models printed in light grey are not translucent and therefore it’s easier to create a good-looking scale paint job. We chose to make the material in light grey colour, that’s the most universal base colour for painting. That means the model is less prone to damage and it actually saves costs. Lowered wing loading results in lower stall speed and impact energy when things go sideways. Since the filament foams up when being printed, a single spool lasts for more than twice the amount of parts in volume, compared to non-foaming filaments. For example, every gram saved on tail parts counts more than twice in the need to balance the model improving weight distribution. PolyLight 1.0 is recommended especially for our LW Planes models designed to be printed in single-pass (vase) mode with reduced travel moves but used wisely it can also be used as a complement to the PolyAir to improve the wing loading of any of our models. Great for LW Planes or weight reduction of any model Foaming during travel moves means more stringing, however, easily removable.Lower glass transition temperature, but with lower volumetric density, less prone to warping on a Sun.Less stiff than PLA – can be controlled by extrusion multiplier and temperature.
![3dlabprint p38 normal or high quality 3dlabprint p38 normal or high quality](https://www.sefsd.org/wp-content/uploads/2018/08/Nose-Art.jpg)
Easy to clean and sand any imperfections.More than double the print volume from a single spool (more than 2kg normal PLA equivalent).Less than half the weight of standard PLA.Suitable especially for smaller models and parts where strength is not so critical. Depending on hotend temperature, the material increases its volume more than twice during extrusion resulting in very lightweight parts. Following the success of our in-house produced PolyAir 1.0 focused on improving the toughness of single-wall printed RC models, we’re presenting the PolyLight 1.0 – The active foaming lightweight LW-PLA material.